 鲜花( 242)  鸡蛋( 8)
|
本帖最后由 白马啸西枫 于 2009-12-31 21:24 编辑
$ k; k1 @/ e& c! Y+ u+ {2 X- \1 X9 l1 R" \0 q3 z5 ^( C: X
22# 小黄
0 S. b: Q7 |/ b5 i$ O
+ {9 g, ?9 b/ j# v" l" y小黄,你说得对,但不全面。9 m* A' L4 V/ Z4 ?0 E
overdrive 档是汽车的最高档,也叫超速挡,超比档,正如shark 27所说: 此时的引擎曲轴转一圈时,齿轮箱的输出轴却可转超过一圈。对引擎而言,就是输出轴端的扭力变小了:4 V7 I$ c& n" c9 v
以下摘自维基百科:
5 B( W$ T E/ n0 k/ v4 x* W' E超比(省油)档开关(O/D):自动变速器的最高档通常是超比档,该档位齿轮比(减速比)低于一,也就是该档位将引擎扭力放大倍数变成低于一倍,有助于省油,但不利于加速。超比开关关闭后,D档行驶时,自动变速器将无法换入超比档。通常在上坡及路面状况不良时应考虑将此开关关闭。
" }0 P0 N0 p1 ?. ~0 F, p8 QA unit with a planetary gearset which turns the driveshaft faster than the transmission output shaft.4 e& P9 b5 m" `4 G/ z
An additional gearbox which is mounted in the driveline. Normally the final drive ratio is 1:1; but the overdrive makes it less (e.g., 0.87:1). The overdrive can reduce gas consumption at sustained high-speed driving, engine noise, and engine wear. Also called "overdrive transmission." Also see aftermarket overdrive
$ F, q0 r$ p& J+ O# N+ dGearing in which less than one revolution of a transmission's input shaft causes one turn of the output shaft. The purpose of overdrive is to reduce engine rpm in high gear for better fuel economy. Example: A transmission with an overdrive top gear has a ratio of 0.70 to one. Turning the input shaft 0.7 revolutions causes 1.0 revolution of the output shaft.
$ m0 d" T8 L# P8 k9 Y7 a因为输出轴端的扭距变小,所以变速箱的设计师有意将其设计成超车时踩油会降档,以提高变速箱输出端的扭距离和加速度,从而使汽车更快地加速。 |
|