 鲜花( 7)  鸡蛋( 0)
|
How to avoid too much chips left in panel box after your drill a hole ?- @0 Y' l" L: N& P. ]$ G/ y( D
3 `4 J" X3 z1 I- X8 r2 r# P
1. If you are going to drill a hole on top of a box, use some paper to cover the bottom of the box so that you can easily remove the paper with chips in it;
( K6 a+ m1 a3 d# \) y5 ~2. Make sure you cover all equipments (breakers, contacts, relays, fuses, Etc)in the box before you drill holes;
9 |5 p8 E; U% l. r3. Use a paint brush to collect all debris (one of the best tools that is always in my tool box), and clean it up before your get all connectors in;
& H4 p8 c- V' z3 ` g4. Use your level's magnetic side to collect all steel chips;: x% K }: y2 d3 G8 ]7 M
5. Use duct tape to get rid of all small chips;/ o* h3 ~ [4 _: U( C
6. Use a vacuum if you just have it beside you(a bit too luxury, but why not!).2 d- a2 Y1 O) q* s! ]
" l6 E, x k8 T$ [" RAnd another vital important point: DO NOT try to below those chips out! Most likely you will just below your mess everywhere, including your precious eyes.
+ b% t& c3 I* j5 \
$ g; j$ P Q; m; F) L) i! H( @( L( ^' h6 k' T( ^1 v5 i
Donate a flower if your think this article is helpful. Welcome all reply, and add some of your secret!+ y$ R% z! ^" l8 X# U) e* Y
* O) z5 R+ N; ~6 t& G
[ 本帖最后由 homestay 于 2009-3-14 19:32 编辑 ] |
|