 鲜花( 0)  鸡蛋( 0)
|

楼主 |
发表于 2010-4-18 15:27
|
显示全部楼层
本帖最后由 jack_lai 于 2010-4-18 16:39 编辑
! F6 c; T5 Y4 ^4 c( ^( _4 W
* x+ B, w" r/ B2 V 9# jjj18 3 s8 @8 H% }' m, h. r0 _! S+ X2 V
Please be aware :( I, ?9 t6 C, O0 P( ^' `( e
1. In order to reach the instruments which are above the Grid Floor A ,see F1 above, cables coming from the Branch Tray C have to pass the Grid Floor A.
+ T5 V* O. Y5 j% |2. If using basket tray to conduct cables, you have to make a hole at the Grid Floor A by cutting a piece of stuff from the Grid Floor A. then the basket trays can go through the Grid Floor A.
" A, x# n8 R. @3. IF using a pipe to conduct cables, because the size of the pip is one inch you can make a small hole at the Grid Floor A by a iron bar(撬棍)
R0 [- ~* Y+ c% H! O4. While you finish one hole for the tray, you can finish 10 holes for the pipe with the same time.! z( J8 ~/ m* o: g5 P% f- c; ^
So to make job easy and fast I prefer to use more pipes.
! o; y3 G8 h" R8 E' e6 a" m As shown on F2, see the Ins A. If x or y is >18 inches I cut a hole for the tray. Y, s6 I" F, {, h" L9 S
The distance of 18 inches is mandatory by SHELL.6 ^4 a* \/ [, P( B) n
In this case about 85% instruments above the Grid Floor A have been serviced by pipes. |
-
|