 鲜花( 0)  鸡蛋( 0)
|
this is what code says:
; d* R- v( F ~, l* s; p4-028: Identification of insulated neutral conductors up to and including No. 2 AWG! Y- H" Q& B% z$ H& e' b) [+ l: Q
copper or aluminum$ v5 E1 H1 c G
(1) Except as permitted in Subrules (2), (3), and (4), all insulated neutral conductors up to and including) D5 ~4 H( d$ {6 _
No. 2 AWG copper or aluminum, and the conductors of flexible cords that are permanently connected to
0 \% j _4 u M. X4 f( nsuch neutral conductors, shall be identified by a white or grey covering or by three continuous white stripes
) D4 D1 y l/ Y* V$ o! {along the entire length of the conductor.# @ r4 I9 L# }, C' k( c$ p
(2) Where conductors of different systems are installed in the same raceway, box, or other type of enclosure7 T1 Q- ^8 G( s% ` ?3 s
and the identified circuit conductor of one system is coloured by a white or grey covering, each identified0 ]. T4 b: k9 {( l$ X+ k# A1 b
circuit conductor of the other system, if present, shall be provided with a specific identification, and the @# p! ~# A' o$ e5 m
identification shall be permitted to be an outer covering of white with an identifiable coloured stripe (not
; C/ [4 W1 [3 S, P! \green) running along the insulation.% |% b- c& \& J$ ?% `: T7 ^
(3) The covering of the other conductor or conductors shall show a continuous colour contrasting that of! N) l* j8 X' i1 e; ~ Q
an identified conductor; however, in the case of those flexible cords where the identified conductor is
! S" J) I( o/ F2 j, e# Gidentified by a raised longitudinal ridge(s), the other conductors shall have no ridges.
) j! V, l0 b, K; T N(4) For multi-conductor cable, the insulated neutral conductor shall be permitted to be permanently marked
3 J& y( j' [3 Q. |$ R: h! P# R7 Ras the identified conductor by painting or other suitable means at every point where the separate
' B! n0 e% Q, v0 T+ M% B+ e2 @! ]conductors have been rendered accessible and visible by removal of the outer covering of the cable, and. f8 x$ r: x, X+ p) p' y- N
the painting or other suitable means of marking the identified conductor shall not be permitted to render
8 _2 [" R, F+ q0 r0 oillegible the manufacturer’s numbering of the conductor. |
|